Adaptec SANbloc S50 Guida di Installazione

SANbloc S50 JBOD Enclosure Quick Start GuideUsing the SANbloc S50 JBOD Enclosure with Snap ServersQuick Install Guidewww.snapserver.com

SANBloc S50 Quick Install Guide 83 If you are not connecting additional SANbloc S50 enclosures, continue with “Powering On” on page 9.Connecting Addit

9 SANBloc S50 Quick Install Guide2 To expand your configuration with multiple SANbloc S50 enclosures, continue to connect the EXP port of the previous

SANBloc S50 Quick Install Guide3 When all SANbloc S50 enclosures are fully powered on, power on the Snap Server.Verifying that an Enclosure is OnlineT

11 SANBloc S50 Quick Install GuideGetting HelpFor additional information about the SANbloc S50 SAS JBOD enclosure, refer to your Snap Server Administr

SANBloc S50 Quick Install GuideAdaptec, Inc. Worldwide Limited WarrantyThe Snap Server Storage Solution hardware carries a Limited Warranty from the d

13 SANBloc S50 Quick Install GuidePURPOSE, OR NON-INFRINGEMENT, OR A WARRANTY THAT THE PRODUCT WILL OPERATE ERROR FREE.IN NO EVENT SHALL ADAPTEC, INC.

SANBloc S50 Quick Install GuideFCC NotificationAuthorized ServiceOnly an authorized service representative can service the Server. Failure to comply w

15 SANBloc S50 Quick Install GuideConnecting to the Main Power — Install the server near an easily accessible power source. Make sure the power source

SANBloc S50 Quick Install Guide• Liquid has penetrated the server.• The server has been exposed to moisture.• The server continues to operate in an un

COPYRIGHTCopyright © 2007, Adaptec, Inc. All rights reserved worldwide.Information in this document is subject to change without notice and does not r

691 Milpitas Blvd.Milpitas, CA 95035 USA408-957-2550www.snapserver.com©2007 Adaptec, Inc.All rights reserved. SnapServer, Adaptec and the SnapServer l

1 SANBloc S50 Quick Install GuideSANBloc S50 Quick Install GuideThe SANbloc S50 JBOD enclosure supports up to 12 Serial Attached SCSI (SAS), 12 Serial

SANBloc S50 Quick Install Guide 2Enclosure Features and Accessories1 Pre-installed disk drives (4 or 12) and pre-installed drive carrier blanks (8 bla

3 SANBloc S50 Quick Install GuideInstalling Your Adaptec Enclosure into a Rack 1 Ensure that you have these rackmount kit components:• Front rails (1

SANBloc S50 Quick Install Guide 44 Remove the plastic covers from the enclosure’s rackmount ears. Caution The enclosure is heavy. To avoid personal i

5 SANBloc S50 Quick Install GuideInstalling Additional Disk DrivesIf the SANbloc S50 enclosure came with 4 drives installed, you can install up to 8

SANBloc S50 Quick Install Guide 6Unsupported Disk Drive CombinationsInstalling the Disk Drives1 Select an open drive slot. 2 Hold the disk drive with

7 SANBloc S50 Quick Install Guide4 Gently push the lever until it meets the latch on the left side of the drive slot and clicks into place.5 Repeat fo