Adaptec 2010S - SCSI RAID Storage Controller Guida Utente Scaricare il pdf (Pagina 104)

4-5

RAIDUTIL Command Line Utility

-D Delete logical drives

This command deletes the specified drives and returns their

capacity to unassigned space. If all is specified, then all logical

drives on the controller are deleted. Logical drives are specified by

the device address. Use commas to separate drive addresses. If

Quiet (-q) mode is not used, a confirmation message is displayed.

Example:

To delete a logical drive at d0b0t0d0, type

raidutil -D d0b0t0d0

-l Specify new logical drive RAID level

This parameter specifies the logical drive RAID level. Valid values

are 0, 1, and 5. RAID 5 is the default.

Example:

To set a logical drive to RAID level 1, type

raidutil -l 1 -g d0b0t0d0

-s Specify logical drive capacity

Specifies the new logical drive’s capacity in megabytes, where a

megabyte equals 1,048,576 bytes (2

If this switch is omitted or if the specified capacity entered exceeds

the maximum available, the maximum possible logical drive is

created based on the capacity of the physical drives.

Example:

To set the capacity of the logical drive at d0b0t0d0 to 500 MB, type

raidutil -s500 -g d0b0t0d0

Combined RAID SW-UG.book Page 5 Monday, September 9, 2002 1:25 PM

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 127 128

Nessun commento

Adaptec 2010S - SCSI RAID Storage Controller Guida Utente Pagina 104