
2-7
Installing Your Controller
Seating the Module
–
Adaptec 3200S/3400S Only
Holding the circuit board and module by the edges, slide the
module into the socket as shown below. Refer to Appendix A for
socket locations.
From the side view shown in the circled areas at the bottom, you can
see that the module is placed into the socket at an angle. Then, press
the module into place until the metal clips click into the sides of the
module and hold it securely.
COMBINED RAID IG.BOOK Page 7 Tuesday, September 25, 2001 5:46 PM
Commenti su questo manuale