Adaptec 2110S - SCSI RAID Controller Guida di Installazione Scaricare il pdf (Pagina 41)

3-6

Adaptec RAID Installation Guide

7 When the system is restarting, a blue screen appears after the

hardware detection message. When prompted to install a

third-party driver, press F6

Note: You only have 5 seconds to press the F6 key during the

installation startup. A hardware detection message appears

when F6 is active. Press F6 at this time; otherwise, you must

restart the installation process to complete this procedure

correctly.

8 When prompted, insert the driver disk you created in Step 1

and select Adaptec I

O RAID Host Adapter Driver for

Windows 2000. Press Enter and follow the instructions

displayed.

Windows NT 4.0

The following driver installation scenarios exist for

Windows NT 4.0:

■ Installing the Driver in a New System with Only One Controller on

page 3-7

■ Installing the Driver in a New System with Other Hardware on

page 3-8

■ Upgrading the Controller in an Existing System on page 3-9

■ Changing the Driver in an Existing System on page 3-10

Caution: When adding a Zero Channel RAID (ZCR)

controller to an existing system, backup all data from

system drives prior to the installation. If the boot device is

connected to one of the onboard SCSI channels, the

operating system will need to be reinstalled after installing

the ZCR controller.

Note: If you choose the Microsoft I

O Operating System

Module (OSM) in place of the Adaptec driver, you cannot

use Adaptec storage management software.

COMBINED RAID IG.BOOK Page 6 Tuesday, September 25, 2001 5:46 PM

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 105 106

Nessun commento

Adaptec 2110S - SCSI RAID Controller Guida di Installazione Pagina 41