Adaptec APA-1350 Guida di Installazione Scaricare il pdf (Pagina 18)

ASI Hardware Installation Guide

Symbios Logic 8100 Kit

The Symbios Logic 8100 card is a plug and play card. There are no jumpers that you have to

configure on the card itself, all you have to do is plug the card into an available PCI slot inside

your computer.

Be sure to turn off your computer, and unplug it before opening.

NOTE: You should have a screwdriver handy before you begin installation of the 8100 card.

The next step is to remove the cover of your computer so that you can see inside. Some

computer systems have screws located on the back of the case that you will need to remove in

order to take off the cover, only the screws holding the cover of the computer on need to be

removed. Some systems require you to pull the cover forward to remove it, some lift right off.

You may need to remove some screws to take the cover off your computer.

IMPORTANT! Before you touch any components inside the computer, touch the metal

case to ground yourself and discharge any static electricity that you may have

accumulated.

Once the cover is removed, locate a free PCI expansion slot. (PCI slots are short, and are

typically white or ivory.) We are going to place the Symbios Logic SCSI card into a slot.

The screw holding the metal plate in must be loosened in order to remove the plate. Once the

plate is removed, place the card into the slot, with the end of the card sticking out the back of

the computer. The picture on the next page shows a free computer slot, with the metal plate

removed.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 33 34

Nessun commento

Adaptec APA-1350 Guida di Installazione Pagina 18