
ASI Hardware Installation Guide
19
Copyright2000, Advertising Specialty Institute. All Rights Reserved. HRDW200001.doc Rev. 5/16/00
In the back of your computer, locate the slot where the SCSI card is installed, the card should
be sticking out of the back.
Take one end of the SCSI cable (that comes with your ASI package) and plug it into the card we
just installed. Tighten the screws so that the cable is firmly connected to the card.
Below is a picture of the back of the DVD player. Plug the end of the SCSI cable into the TOP
port of the DVD player. (The other end of the cable is connected to the card you installed in
your computer.)
Included in the DVD package there is a small gray connector, called a “terminator”. Put the
terminator on the BOTTOM port of the DVD player.
Plug the power cable into back of the DVD player, and turn the DVD player on.
Plug the power cable back into your computer, and turn your computer on. (If you had to
disconnect any other cables to install the SCSI card, you should reattach those cables at this
time.)
When you turn your computer on, Windows will detect the card and install the appropriate
drivers automatically.
At this point your computer may ask you for the Windows CD-ROM disc. The computer needs
to copy the SCSI card drivers from the CD-ROM onto your hard drive. If you have a CD-ROM
drive that is currently installed and functioning (perhaps an internal player that is built into your
computer), put the Windows CD-ROM into the drive. If you do not have a functional CD-ROM
player, or you do not have a Windows CD-ROM available, you have been sent a floppy diskette
that contains the drivers you need. Simply put the diskette into you’re A: drive, and when
Windows asks for the CD-ROM, choose the A: drive.
Once you are back into Windows, you can make sure your 8100 driver software has been
installed properly.
From the desktop, click on Start, then Settings, then Control Panel.
In the Control Panel window, click on System.
Click on the Device Manager tab.
Click on the plus sign located to the left of SCSI Controllers.
Commenti su questo manuale