Adaptec APA-1350 Guida di Installazione Scaricare il pdf (Pagina 22)

ASI Hardware Installation Guide

Power Domain 2930 Kit

The Power Domain 2930 card is a plug and play card. There are no jumpers that you have to

configure on the card itself, all you have to do is plug the card into an available PCI slot inside

your computer.

Make sure your computer is turned off. For added safety, unplug the power cord.

NOTE: You should have a screwdriver handy before you begin installation of the 2930 card.

The next step is to remove the cover of your computer so that we can see inside. The manner in

which you cover is attached to your case may differ from the model in the picture below; please

refer to your owner's manual in regards to this matter.

IMPORTANT! Before you touch any components inside the computer, touch the metal

case to ground yourself and discharge any static electricity that you may have

accumulated.

Once the cover is removed, locate a free PCI expansion slot. (PCI slots are short, and are

typically white or ivory.)

In order to insert the card you must first loosen the screw that holds the metal plate in place,

then, remove the plate. Once the plate is removed, you should be able to place the card into the

slot, with the end of the card sticking out the back of the computer. The picture on the next page

shows a free computer slot, with the metal plate removed.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 33 34

Nessun commento

Adaptec APA-1350 Guida di Installazione Pagina 22