Adaptec 1542B - AHA Storage Controller Fast SCSI 10 MBps Specifiche Scaricare il pdf (Pagina 57)

DPU4E Maintenance Utilities

located toward the middle of the board when the board is stood

up as if inserted in a rack.

Insert the DPU into the chassis.

At the PC’s DOS prompt (C:\) type: CD PEBDM <enter>.

At the PC’s DOS prompt (C:\PEBDM\) type: PROG32<enter>.

The program will display a menu and status screen.

Press <esc>.

On the displayed menu screen cursor to the selection: RE Reset

<enter>.

Cursor to CM Choose Algorithm Module <enter>.

If U31 is an Intel chip, on the displayed menu screen cursor

down to the selection: i8_200tw.32p <enter>.

Or, if U31 is an AMD chip, on the displayed menu cursor down

to the selection: am9200bw.32p <enter>.

On the displayed menu screen enter the BASE MODULE

ADDRESS as: 0 <enter>.

On the displayed menu screen cursor down to the selection: SS

Specify S Record <enter>.

Enter the file name with “.S3” extension for the module to be

programmed:

If the 081976 Disk is in the Floppy Drive then use the drive

letter reference (i.e. a:\081976X.S3, where X is replaced by the

Current Revision Letter).

For example, 081976A.S3 DPU4E IOM Version 1.0 Rev A

Firmware

Press: <enter>.

On the displayed menu screen cursor all the way down to the

selection: BE Block Erase. <enter>.

Type: <0 enter> for block 0

Repeat BE for blocks 1-4.

The bottom of the display should show the erase status: DONE.

If problems are reported, then start over from step 1.

Metso Automation • 278590 •

A-11

1 2 ... 52 53 54 55 56 57 58

Nessun commento

Adaptec 1542B - AHA Storage Controller Fast SCSI 10 MBps Specifiche Pagina 57